Parts index
We stock over 22 Engine tools
We stock a wide range of tools for working on your Lambretta engine. From our engineering background we firmly believe in using the right tool for the job, so we made our own tools. The tools are either based on original items or are from our own design.
MBL0007
This is the unusually sized allen key you need for most gear and clutch cable trunnion on a Lambretta.... [more]
MBP0358K
Using this tool is the best and safest way to remove your Series 1, 2 and 3 Lambretta rear hubs. You simply bolt... [more]
MBL0698
Many uses for this allen key including MB remade gear trunnions.... [more]
MBL0703
This 10mm allen key can be used for the crankcase side drain and level plugs amongst other things.... [more]
MBL1390
This is a high quality 10mm movement dial gauge. It can be used with our cylinder head dial gauge bracket kit to set... [more]
MRB0149
This is a MB steel clutch holder, which will let you safely and easily hold your clutch assembly while you undo and tighten the... [more]
MRB0150K
This is our MB Lambretta clutch compressing tool. Designed to safely compress your clutch while you change the clutch plates. It mounts... [more]
MRB0155
Another tool copied from the original with a slight MB improvement. We remade these T bar extractors in slightly different lengths so the handles ... [more]
MRB0156
This tool will work on any single cylinder vehicle. It is designed to rest on the base gasket face and hold your con-rod (and therefore... [more]
MRB0157
This is a copy of the original tool as supplied with all new Lambrettas. It fits in a small hole under the rear of your... [more]
MRB0201
There is no point spending money on a crank that has been checked for alignment then going and hitting it with a hammer to... [more]
MRB0202
Fitting the large oil seal into the magneto flange can be quite difficult so Mark came up with this tool to easily and squarely... [more]
MRB0251
This MB tool is designed to make it easy and safe to refit the gearbox end plate bearing with out damaging the bearing. It's designed... [more]
MRB0252K
It is important when fitting the layshaft and checking the tolerances in the gearbox, that the layshaft is pulled all the way into the... [more]
MRB0253
This tool will hold 90% of Lambretta flywheels. It is double ended and will hold normal Italian Series 3 type flywheels as well as the... [more]
MRB0254
This tool is designed to safely and easily fit the inner bearing sleeve from a flywheel bearing to the crank. You just fit the sleeve... [more]
MRB0415K
This bracket kit is designed to be used with any Lambretta, P range, T5 or small frame Vespa. It is designed to put your... [more]
MRB0433K
This Dial gauge bracket kit is designed to be used with any Lambretta, Vespa P range, T5 or small frame Vespa. It is... [more]
MRB0662
This timing disc has been specially designed by us for using on Lambrettas and can be used on engines fitted with GP crankshafts. ... [more]
MBU0270
This simple allen key tool is ideal for the drive side sealing plate screws. It is also used on my other universal fasteners.... [more]
MRB0966
Theres plenty of ways to fit and remove a bearing, it's the same with a drive bearing. On a good casing if warmed enough a... [more]